There is lots of research, finding parts, ordering bits and pieces from around the world. Why would you build one? This comes in significantly under that. The actuators are a combination of a Servo Drive, mounted to Ball Screws with a bunch of 3D Printed and off the shelf parts. What is it? Essentially a DIY linear actuator design, with software SimFeedback and an Arduino firmware package to drive 4 actuators in a platform mover design. A handful of videos later with some very interesting quotes got the ball rolling - some people were comparing it to a middle of the road between a SCN-6 based unit to a top end DBox unit. Doing the sums my ears pricked up, or more to the point I got my google on to research it. It was going to happen sooner or later, a motion platform for the sim rig.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |